Take a Closer Look
FAQ
400mm*415mm
Semiconductor laser unit
It is convenient to measure the size of the object and assist in locating the engraving area.
It will stop working. The machine will be initialized when powered on.
The imported image should be clear. Make sure that focusing correctly before engraving and the power and speed are appropriate.
Check that the screws are tight and the belt is not too loose or too tight. The tightness of the belt is appropriate if the laser module can slide slowly on the X-axis profile perpendicular to the desktop by gravity and any pulley in the laser module has no empty sliding.
Ensure that the material to be engraved is flat. Observe the gradient on the machine to ensure that the machine is horizontal, and has been properly adjusted according to the operation method of the user manual.
The laser may penetrate the material and damage the workbench (especially when cutting). It is recommended to place objects on the bottom that cannot be penetrated by the laser, such as stainless steel plates, aluminum alloy plates, etc.
Please check if the TF card is inserted. The machine reads the latest engraving file(.gcode/.gc/.g/.nc/.ngc) in the root directory of the TF card by default. It is recommended to delete other engraving files in the root directory.
Take out the filter cotton directly when powered off. Clean it with water, dry it, and put it back (or replace it with a new one). Be careful not to touch the protective lens of the laser module.
In preview and engraving modes, if the machine turns on its side or moves, it will turn off the laser. The motor stops moving, the indicator light flashes, and the buzzer emits an alarm.
Solution: Please move the machine to its original position and press the microswitch on the control box to continue previewing or engraving after clearing abnormality (The microswitch only works during offline working).