Take a Closer Look
FAQ
1. Heat the spray head to 230 degrees Celsius and keep the same temperature to remove the spray head kit; and then remove the heating block and throat separately. After removing, the spray head can heat to the lower temperature.
2. Prepare a bottle of red glue (available from Taobao), apply the red glue to the thread of the throat, let it rest for 1 minute, then reinstall the throat and heating block, and then install the nozzle kit back to the original Bit;
3. If there is still the same issue, please contact the after-sales customer service.
1. Please check whether the temperature display on the display is normal room temperature without giving the heating command. If it is not, it is likely to be a thermal problem, just replace with a new one;
2. Measure whether the output voltage of the hot bed port of the main board is 24V under heating. If there is no voltage, it is a main board problem and need to be replaced with a new main board. Otherwise, it is likely to be a problem with the hot bed board itself and need to be replaced.
Generally, it can be assembled in 5-10 minutes.
Please heat the nozzle to 200 degrees Celsius at first; then use cutting pliers to cut and straighten the front end of the filament at a 45-degree angle; and then open the extrusion clamp, pass the filament into the extruder kit along the cut-off detection aperture;until the filaments flow out from the machine nozzle.
The machine has the function of continuous power off, it can continue printing when the power is restored normally.
But the connection effect may not be very good, there is a certain chance that it will fail.
1. Under the condition of no heating, determine whether the temperature of the display screen is normal room temperature. if not, it is likely to be a thermal problem, please replace a new one;
2. Under the condition of the heating, test whether the output voltage of the nozzle port of the main board is 24V. If there is no voltage, it is the main board problem. Please replace the new main board. Otherwise, it is likely to be a heating tube problem. You need to replace the heating tube.
1. Slicing problem, the slicing is unsuccessful or not completely exported, just re-slicing or waiting for the export progress buffer to be completed.
2.The file transfer is interrupted during the SD card printing process, please replace the SD card or format it to have a try.
3.If it's still the same issue, please contact the customer service.
1. Clean the fan and check whether there is debris interference ;
2. Check whether the screws and fan cover are loose, and then re-fix it;
3. Check if the fan blade is damaged or broken, please replace a new fan.
1. Format the SD card;
2. Check whether the card slot is loose;
3. Please clean the card slot with alcohol to oxidize it;
4. Replace the card slot / motherboard.