Home / Blog Center / Creality K2 Plus Mainboard Replacement Guide

Creality K2 Plus Mainboard Replacement Guide

Tutorial
2025-05-28 05:35:58

Replacing the mainboard on your K2 Plus 3D printer can help resolve hardware issues and extend the machine's lifespan. Follow this step-by-step guide to safely remove and install a new mainboard.


Tools You’ll Need

  • H2.0 hexagonal wrench
  • H2.5 hexagonal wrench
  • Cutting pliers
  • Cable ties
  • New mainboard

Mainboard Location

The mainboard is located in the lower left corner at the back of the printer.

Step-by-Step Instructions

1. Power Off the Machine

Turn off the printer and unplug the power cord before beginning any disassembly.

2. Remove the Back Panel

Use H2.0 and H2.5 hexagonal wrenches to unscrew the back panel.

Carefully remove the panel to expose the internal wiring and mainboard.

Brick Layer

3. Detach the Mainboard

Use cutting pliers to remove the cable ties that secure the wires.

Note: Be cautious not to cut any ribbon cables.

Brick Layer

Unplug all connected wires from the mainboard.

Brick Layer

With a H2.0 hexagonal wrench, remove the four M3 screws that fix the mainboard in place.

Brick Layer

Gently lift and remove the damaged or faulty mainboard.

Brick Layer

4. Install the New Mainboard

Align the new mainboard with the mounting holes and ensure the direction matches the original board.

Brick Layer

Use the H2.0 hex wrench to fasten the four M3 screws.

Brick Layer

5. Reconnect the Wires

Refer to the official mainboard wiring diagram.

Plug each connector into the correct port on the new mainboard.

Important: Miswiring can cause secondary damage to the printer.

Brick Layer

Brick Layer


Function Test

1. Plug in the power cord and turn on the printer.

2. Touch the screen and test the machine’s key functions:

  • Heating
  • Axis movement
  • Fan operation

3. Ensure everything works as expected.

4. Power off and unplug the printer after testing.

Final Assembly

Tidy up the internal wiring and secure loose cables using new cable ties.

Reinstall the back panel using your H2.0 and H2.5 wrenches to secure all screws.

Brick Layer

Video Tutorial

For a visual walkthrough, check out our full K2 Plus Mainboard Replacement Video Tutorial.

People also read:

How to Switch K2 Plus from CFS to Spool Holder Filament>>

Creality K2 Plus Hotend Replacement >>

Creality K2 Plus Error Code Correspondence Table >>

    Share